Siding Contractors in NJ | Siding Installers in Morris County NJ

NJ SIDING CONTRACTORS in MORRIS COUNTY

Hear What Our Customers Have To Say!

Eliminator XL29 Insulated Siding
w/ patented Glide-Lock Attachment System
"The only 29' Siding Panel on the market today!"

The new and patented attachment system is designed to stop the expansion and contraction problems when vinyl siding is nailed or attached incorrectly. The ferrule studs are evenly placed in 4" increments. You no longer have to worry that the nail was placed too far to one side of the nailing slot, or angled too high or too low.

By fastening the siding through the ferrule studs, each fastener is now in the correct position. The ferrule studs also prevent the nail from being installed upward or downward.

Now the attachment strip is fastened to the wall and allows the siding to expand and contract freely. Eliminator XL 29 is attached with exterior screws for peace of mind installation. Eliminator Insulated siding is available in a range of beautiful architechural colors.

Seamless or...	ELIMINATOR XL29 VS. 12' ORDINARY SIDING PANELS

Unnecessary seams?	If both siding jobs were free, Which would you choose? Then why would you pay for siding that you would not want for free?

Request
Eliminator
XL 29!

About the Glide-Lock attachment system
Eliminate siding like this by requesting the Eliminator XL 29 Glide-Lock!

The way vinyl siding is attached to your home today is the same as back in the late 1950's. The siding panels have improved greatly but the nailing hem hasn't changed much in almost 50 years.

According to the manufactures and vinyl siding institute's installation instructions, every nail must be installed exactly in the center of the nailing hem nail hole. If you are too far to the left or right, it can interfere with the expansion and contraction of the siding and you will see warping, wavy walls. Each nail must be installed straight into the wall, not pointing upward or downward. And to make matters even harder, each nail must be installed leaving 1/32" away from the wall. This must be done approximately 2500 times on an average siding job. If it's not done perfectly all 2500 times you could see warping and wavy walls as seen in this photo on right.

Did you know that you can go in any direction within 1 mile from where you are and see bad siding jobs ? The Eliminator XL 29 solves this and makes every home look beautiful and straight walls every time.

Lifetime written warranty labor and materials.

MORRIS COUNTY NEW JERSEY : #1 SEAMLESS VINYL SIDING COMPANY

Mid-America Siding Components

Cedar Shakes
Here you can select a home and decorate it with Morris Cedar Shake Shingles.

100% Financing available